Is there anything more fun than listening to E Skip? Or staying up all night logging long haul tropo, or going to bed at 4am and getting up for work at 8?
 

 

 

Channel Master Probe-9 (Model #4408)

UPDATED WITH PHOTOS ON Jan 29, 2013


Model 3025 - Previously Model 4408


 

The Channel Master Probe-9 (model 3025) was a workhorse. It was one of the most popular FM antennas in use today by FM Dxers and audiophiles. Gain is good, directivity and front-to-back ratio are good. 

 

THIS ANTENNA IS NO LONGER BEING MANUFACTURED.

 

The antenna consists of four folded dipoles (d1 through d4) which are all driven. In front of the dipoles are 5 directors (1-5). Note that there is no reflector as such. The last dipole acts as a reflector. Each dipole is tuned to a specific portion of the FM band. Spacing between each director is 15 inches (38.2cm). Spacing between dipoles is 20 inches, or 50.8cm.

 

This is the last of the four dipoles. The harness runs from the top of the last dipole to the top of the next dipole.

 

 

 

 

 

 

 

 

 

 

 

 

 

This is the connection from the last dipole to the second dipole. Notice the harness runs under the antenna boom to the third dipole.

 

 

 

 

 

 

 

 

 

 

 

 

 

This is the connection to and from the third dipole. The harness runs over the boom to the fourth dipole where the antenna is connected.

 

 

 

 

 

 

 

 

 

 

 

 

 

Here we are at the fourth dipole where the antenna is connected and where the two booms are connected. The dipoles have about 2.25" of airspace between upper and lower halves.

 

 

 

 

 

 

 

 

 

 

 

 

 

And finally this is the rear half of the Probe 9. The dipoles are not fully extended due to lack of space.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Total Length of All Elements

 


 
Total Length tip-to-tip
Director 1 48 inches/ 122cm
Director 2 49 inches/ 125cm
Director 3 49 inches
Director 4 49 inches
Director 5 50 inches/ 127.5cm
Dipole d1 54 inches/ 138cm
Dipole d2 63 infhes/ 160cm
Dipole d3 68 inches/ 173cm
Dipole d4 74 inches/ 189cm

 

Notice that dipoles d1 and d4 are connected on the bottom of the dipoles, while dipoles d2 and d3 are connected on both the tops and bottoms of the dipoles and that the connections do not cross as on the Finco design.

Total length of the 3025 boom is about 137 inches, allowing an inch or so extra on each end. The connection to your lead/balun is at the bottom of dipole d1.

Please use this information for comparison purposes only.

 

Additional Information:


Note on dipole connections: To connect the dipoles, Channel Master used the same
gauge tubing as their antenna elements (3/8 inch). Connections from d4 to d3 are from the bottom
of the dipoles. Connections from d3 to d2 are from the TOP of the dipoles and
connections from d2 to d1 are from the bottoms of the dipoles. Dipoles d3 and d2 have
both bottom and top connections. All dipoles are completely insulated from the mast
and all connections run parallel to each other (they do NOT cross). Directors are NOT insulated
from the mast.

 

Copyright 2012, 2013©M. Bugaj No reprinting without permission.